Triumph Fiber Laser Cleaning Machine Process Parameters
Parameters Explained
- Scanning frequency: Swing speed of motor, ranging from 10 Hz to 100Hz, 50 is recommended.
- Scanning width: The scanning width of the light spot, ranging from 0 to 0-300mm, should be selected in the system settings according to the specifications of the actually used focusing lens.
- Peak power: Generally, it defaults to the maximum power of the laser.
- Duty cycle: Duty cycle range 0 to 100 (default 100, usually not changed).
- Frequency: Range is recommended from 5-5000Hz (default 2000, usually not changed).
- Endpoint optimization: Range -30~30, which can eliminate the phenomenon of uneven light out at both ends of the cleaning track, and different scanning frequencies correspond to different optimal parameters. The default is 0.
After setting the parameters, import and return, and you can see this process on the left side of the home page.
Confirmation of focus
By scanning back and forth for a long distance, the focus is when the sound is the loudest and the spark is the biggest. At this time, cleaning should be carried out according to this distance, and the energy is the strongest.
According to the use of focusing, the following is a reference.
F400 focusing (generally, the distance from the gun head to the plate is about 35-40 cm, and the energy is the strongest).
F800 focusing (generally, the distance from the gun head to the plate is about 65-75cm, and the energy is the strongest).
Use of gas
The gas cylinder needs to increase the pressure reducing valve, if the pressure is too high, it will damage the gas pipe.
Gas selection for cleaning: Air with a pressure not less than 5 kg/cm², filtered through three-stage or higher oil-free and water-free filtration, or use other inert gases.
(Note: “5 kg/cm²” is equivalent to approximately 0.49 MPa or 71 psi.)
When cleaning, please keep the distance between the gun head and the plate steady and the hand speed even.
Laser Power | Material | Speed | Cleaning Range | Depth of Cleaning | Cleaning efficiency |
1500W | Floating Rust | 50mm/s | 150mm | 20μm | 15㎡/h |
1500W | Paint | 50mm/s | 150mm | 100μm | 6㎡/h |
1500W | Corrode | 50mm/s | 150mm | 120μm | 4㎡/h |
2000W | Floating Rust | 50mm/s | 300mm | 20μm | 20㎡/h |
2000W | Paint | 50mm/s | 300mm | 100μm | 8㎡/h |
2000W | Corrode | 50mm/s | 300mm | 120μm | 5㎡/h |
3000W | Floating Rust | 50mm/s | 300mm | 20μm | 30㎡/h |
3000W | Paint | 50mm/s | 300mm | 100μm | 14㎡/h |
3000W | Corrode | 50mm/s | 300mm | 120μm | 9㎡/h |